his project was built and tested with WinAV R-20060125. Make sure the MCU target define in t he Makefiles corresponds to the AVR you are usin g! ! To build the code, WinAVR just install and run "make" from the cons Morning in echomaster and echoslave subdirs. "make program "will program the device if you have a AV RISP attached. Remember to set the device to AVR at least 8MHz. The AVR may use the programmable c lock from MC1319x. just remember to check if the MC1319x and SPI com munication is working FIRST! Otherwise you will t get any clock signal to the AVR and then you can not program it or reset the fuses! The MC1319x has de fault clock output of 32kHz so you will have to se not your programmer to a very low frequency (

Packet : 73462683anteeobee_20060218.zip filelist
cmn/
cmn/ledfeedback.c
cmn/ledfeedback.h
cmn/mc1319x.c
cmn/mc1319x.h
cmn/usart.c
cmn/usart.h
echomaster/
echomaster/echomaster.c
echomaster/Makefile
echoslave/
echoslave/echoslave.c
echoslave/Makefile
README.TXT

• We are an exchange download platform that only provides communication channels. The downloaded content comes from the internet. Except for download issues, please Google on your own.
• The downloaded content is provided for members to upload. If it unintentionally infringes on your copyright, please contact us.
• Please use Winrar for decompression tools
• If download fail, Try it againg or Feedback to us.
• If downloaded content did not match the introduction, Feedback to us，Confirm and will be refund.
• Before downloading, you can inquire through the uploaded person information

Nothing．